More battery and big winds
Thursday, February 25th, 2010Pulled the battery today. Did it today instead of tomorrow as the winds are going to be pretty stiff around here tonight and tomorrow. The terminal area forecast for Dulles (IAD) is predicting gusts up to 49 kts tomorrow morning at 8 AM (1300Z). DCA (National) and MRB (Martinsburg) are reporting similar but slightly lower values. You have to get to Elkins WV or Richmond VA to see significantly lower values. Nevermind, at the predicted 49 kts (56 mph or 90 kph) that’s more than enough.
I used the opportunity to check the tiedowns on the plane as well. Tying a plane down is important, a surprising number of planes get damaged not while flying but during storms on the ground. Tie downs are important enough that the FAA wrote an advisory about it (AC20-35C) and good instructors make a point of teaching them.
Chains seem very secure and last a long time, but don’t have any flex. So when the plane surges against them there’s a very strong jerk on the plane. That can’t be good! We use straps like these with rachet tighteners that are good for almost 3000 lbs per strap. Ours are around a year and a half old now, so probably should be de-rated somewhat but they’re still quite good. Back when we used ropes I used to double them against big winds sometimes. I don’t feel the need for that now.
I pull the straps snug. I want the strap to stretch when a wind comes, not to jerk against the plane. Stretching is good, jerking is not. The impact force of the jerk is very high and can damage both the tie down strap and the anchor point on the plane.
This evening there are gusts up to 38 kts so far. When I pulled the battery it was only gusting up to 25 kts. A friend at the airport was kind enough to help with the cowling. The battery’s in the engine compartment under the front cowling. It’s not like a car’s hood - there’s about 25 or more screws holding it on and it’s picky about fiting correctly. And with a wind that large piece of sheet metal can act like a nice sail. I had a plan for doing it myself, but two people make the job easy. So thanks “Dutchman”!
It was too cold with the wind chill to spend time looking at cables today; that’ll be for later. And how’s the battery? The open-circuit (no load) voltage is 11.7, that’s low, but not drastically so. Sounds more and more like a cable and grounding problem.
